Commercial Vehicle - Maximum Passenger Capacity Sticker

You must check your log card for detail via One Motoring to determine the PAX limit before you make the purchase for the sticker or magnet.

Yes, we can, but we do not hold any responsible if you receive any fine or fail your vehicle inspection, as colouring the Pax limits mark is considered following the standard set out by the authorities.

Additional charges are required for colour that is not standard (Black & White or Black Yellow)

No, we do not provide a pasting service.

It is not very hard to paste. Here are the steps:
1. Remove existing if there is any.
2. Clean the surface; ensure there is no dirt and it is smooth to paste.
3. Spray some soapy water on the surface and the adhesive side of the sticker after peeling off.
4. Paste and adjust the sticker to your liking and gently squeeze the excess air and water between the sticker and the surface with a Scraper / Squeegee.
5. Let it dry, and you are done.

Scraper / Squeegee can be bought at $1 on our website with your side markings order. If not, you can also use a card but be extra careful with the surface as it's not anti scratches.

Our customers have expressed their satisfaction with their purchase from us, as we haven't received any complaints. You can trust us to provide a high-quality product that meets your needs.

Our magnet sheets and strips are typically coated with a protective layer of black epoxy. This coating serves two purposes: it safeguards the magnet from environmental factors and gives it a polished look. The strips are engineered to meet high tolerance and density requirements, ensuring consistent application performance.

We highly recommend that customers regularly inspect their magnets by removing them and checking for any signs of water damage. If any water is found, it should be dried up immediately. Additionally, if there is any magnet sheet or strip damage, we suggest ordering a new pair to avoid stains or rust buildup.