Making a brand new office signage and install using existing drilled holes.

Step 1.

See if there are any wall plug in the holes.

If Yes > take pictures of the wall plugs and let us know, if there is any missing please inform us.
If No > take pictures of the holes to check if is suitable for installation.




Step 2.

Measure the holes (with our without wall plug).

Note:
- Give us the diameter of the holes.
- Measurement must be point A the center of the hole to point B center of the hole. (please see image below)






Step 3.

We will need to know the new estimated size you need to make (please see image below).

Note: 
- Size should not be smaller than the holes area.
- Give spacing around each hole area (20mm to 25mm)




Please make sure the measurement is accurate if not the new signage might not be able to fit in and may require to re-make another new piece. You can also check with our staff to arrange site measurement (this service is chargeable).


Updated on 1st January 2016